• Home
  • Browse
  • Search
  2. MotoIQ
  3. Project Cars

Level Motorsport M86 Build - Rocco

Read More
Untitled photo
198 / 815

  • A mistake in mixing the epoxy in the right proportions, or even for too long can cause many undesirable results.
  • More hardener doesn't just make the material cure faster. It can generate massive amounts of heat if it cures too quickly (enough to melt plastic), which is obviously bad for your mold, or not cure at all. It is important to stick to the specified proportions.
  • Untitled photo
  • Untitled photo
  • Untitled photo
  • The first layer of resin goes down.
  • Fiberglass goes on top.
  • Then more resin!
  • All the resin.
  • Untitled photo
  • Once covered in epoxy, the excess fiberglass is trimmed away, and the remaining sheet is pressed down using metal rollers to ensure all the crevices are seated properly, with no air bubbles.
  • Untitled photo
  • Hungry, the two venture outside in search of food.
  • Prep to mold new carbon fiber door panels starts with the removal of hardware like the door handle and window regulator.
  • Untitled photo
  • Untitled photo
  • Untitled photo
  • Untitled photo
  • Untitled photo
  • Untitled photo
  • No Comments
  • Photo Sharing
  • About SmugMug
  • Browse Photos
  • Prints & Gifts
  • Terms
  • Privacy
  • Contact
  • Owner Log In
© 2021 SmugMug, Inc.